Terminator™ Beacon THERMON

Terminator Beacon end-of-circuit light kits are designed specifically for rapid, trouble-free installation of Thermon self-regulating and power-limiting, parallel resistance polymer insulated heating cables. The integral design of these nonmetallic kits combines the pipe-mounted fitting, heating cable grommet and cable strain relief with end-of-circuit voltage indication into a single assembly. Screws have been eliminated from the kits to simplify installation. The Terminator Beacon utilizes a high intensity green LED assembly for superior day or night visibility. This light is also available with a high intensity red LED. A domed lens allows for enhanced viewing from elevated locations. Terminator Beacon kits are approved for use in ordinary (nonclassified) areas, and are certified to the ATEX directive for use in Category 2 and 3 (Zone 1 and 2) classified area’s.

RATINGS
Ingress Protection.................................................... IP66
Maximum pipe exposure temperature .................250°C
Minimum installation temperature ........................-60°C
Operating voltage rating 1 ........................... 100-277 Vac
Operating ambient temperature............ -60°C to +55°C
T-rating
Ambient less than 45°C..................................T6 85°C
Ambient up to 55°C......................................T5 100°C

TERMINATION KIT
SCTK Kit (purchased separately) is required to terminate the cable ends.
For termination with crimp lugs
SCTK-1 for BSX, RSX, and VSX-HT cables
SCTK-2 for KSX and HTSX cables
SCTK-3 for HPT and FP cables

For termination with terminal block 1
SCTK-1TB for BSX, RSX, and VSX-HT cables
SCTK-2TB for KSX and HTSX cables
SCTK-3TB for HPT and FP cables

Note 1. When SCTK-*TB is used in an Ex e area, max voltage is 275 Vac.

CERTIFICATIONS/APPROVALS
Terminator Beacon kits have the following approvals when used in conjunction with Thermon heating cables: